.search

Back Taper on Punches

PASS punches are normally produced with back taper to reduce galling and premature punch wear.

		However it should be mentioned that back taper is very important when punching materials such as Stainless Steel or very thick material to reduce galling and eliminate breakage of the tool corners and edges.
If you have any further questions please do not hesitate to contact our sales engineers.

	17.04.2012 BIAM 2012

	International exhibition for machines tools » Read more...

	06.06.2011 PASS Ball-Deburring Tool V3

	Double-side deburring close to edges » Read more...

	06.06.2011 PASS Knock-Out Technology

	In the daily life, installers and electricians are confronted with the challenge to position cables in the correct position of an electrical... » Read more...

PASS Stanztechnik AG .Am Steinkreuz 2 .D 95473 Creußen .Phone +49 9270/985 - 0 .Fax +49 9270/985 - 99 .email: info@pass-ag.com